Ruger Collectors Association

Welcome to the forum from central PA. Lots of Ruger knowledge here.

Don,
More great stuff. It just amazes me how you come up with all these advertisements. I did notice the grips on the model shown are one of the later styles Ruger used.

For both of your questions you would be very well served by joining the Red Eagle News Exchange. The author has many years researching Ruger products and the Reference of Ruger Firearms is considered the encyclopedia of all the Ruger knowledge. Join here: Red Eagle News Exchange c/o Chad Hiddleson 1...

Thank you Don for posting it. This was my first NRA Convention experience. Have been meaning to go to them in the past but something always seemed to come up. I am honored that the RCA asked me to do a display for them, I was proud to represent them and show people what Ruger Double Actions were all...

If it will fully seat a .38 Spl round, it makes me think that the wrong barrel or the wrong cylinder was installed. You could, if you have the right equipment, measure the barrel diameter. Or, if you reload and have both 9mm (.355) and .38 (.357 or .358) bullets (just the bullet) see which one fits....

Very nice set, should suit you very well up in AK.

I'm primarily a Ruger DA guy that those are some fine looking 3 screws. Thanks for posting.

Thanks John, It will get here when it get here Always good reading. I may even try my hand again at writing an article, got a couple of ideas floating around in my little pea brain.

Dropping my order in the mail this morning.

Was at the Huntsville, AL gun show Jan 4 & 5 displaying some of my Rugers with other Ruger collectors Not really looking for anything but had this fall into my lap today at the show. Guy came to my display and asked if I bought guns. Showed me a gray box that the end label said MKIII512TA (10131...